@Technology

Die
Die makes the quality of product.

Having the long experience to produce logos which perform an important role to represent your company , Shinko do a lot of detail work such as:

- Mirror finishing without any scratches.
- Processing with the end mill which width is only half the thickness of a human hair.

Molding
Keep upgrading molding technologies with up-to date facilities.

We were early adopter of the electric injection molding machine which reduces manufacturing variations.

Also, we have upgraded other facilities:
- Vertical insert molding machine
- Dichromatic molding machine
- Special molding machine which enables ultra thin-walled molding (t=0.15mm)

Coating
Coloring is the essential process for Shinko Products. Especially, coating needs delicate techniques.

Shinko succeeded in ultra thin film coating which can represent a molding figure as it is. We can realize about 2ƒÊ thin film coating by robot.

Any contaminations in several micrometers are not allowed on UV Hard coating. It is indispensable to apply UV coating in a clean room environment.

Shinko was an early adopter of UV coating in a clean booth and also have installed fully-automated line from input to ejecting.

PVD
Having the experience to deal in the real metal, we stick to make plastic products which seem to real metal.

In order to realize such products,

- we have a wide variety of deposition equipments; heat thermal resistance, sputtering, electron gun.

- we have multi-chamber type evaporation system which enables evaporation process in seconds.

- we succeeded in evaporation which does not cause radio disturbanceEESD.


Printing
We succeed in applying gradation printing on 3D curve by screen printing.

Also, we developed automatic screen device for multi color on 3D curve in partnership with a printing machine maker.

Laser
Laser Marking iYAG Laserj
- Enable to remove the characters and unnecessary parts.

- Enhance positioning accuracy of marking by combining with our unique sheet forming technology.

Laser CuttingiCO2 Laserj
By combining with Shinkofs unique sheet forming technology,
- Enable to laser-cut entire perimeter of a products and that eliminates the gate cut mark.

- Enable to laser-cut a product with double-faced tape and that enables to put the tape on whole back side of the products.
Stamp
ERegarding thermal transfer by stamping foil, we have 2 types of stamp machines, gUp-downh and gRollerh.

EWhile the existing process, electroforming and alumite are expensive, Shinko realized a lower-cost products by combination of our unique sheet forming technique and dia-stamping.

We have been providing several hundred types of such products to the customers.

Quality
Those Shinkofs unique technologies have been producing the premium quality products.

In order to mass-produce such products, we are advancing quality improvement and process upgrading.

Also, for environmental quality, we observe material selection and global environmental standards.


Copyright(C) 2010 Shinko Nameplate Co., Ltd. All Rights Reserved
Die
Molding
Coating
PVD
Printing
Laser
Stamp
Quality
Contact

Shinko Nameplate Co., Ltd.


1-11-9 Tana Shioda Chuo-Ward Sagamihara-City Kanagawa-Pref.
252-0245 JAPAN

TEL +81 42-777-7271
FAX +81 42-777-2110


E-MAIL
info@shinko-name.co.jp